Page 1 of 1

How to translate code use Q_OUTOFLINE_TEMPLATE?

Posted: Thu Apr 16 2020 5:03 pm
by opaque
I'm stuck with this Q_OUTOFLINE_TEMPLATE.

Re: How to translate code use Q_OUTOFLINE_TEMPLATE?

Posted: Thu Apr 16 2020 7:26 pm
by tim
This is an old macro that is not needed when using CopperSpice. You should be able to safely remove it for your project.

NB. In this case I managed to figure out your question fairly quickly, but for a next question it would be great if you could add some context or maybe an example :D.

Re: How to translate code use Q_OUTOFLINE_TEMPLATE?

Posted: Fri Apr 17 2020 4:45 am
by opaque
tim wrote: Thu Apr 16 2020 7:26 pm This is an old macro that is not needed when using CopperSpice. You should be able to safely remove it for your project.

NB. In this case I managed to figure out your question fairly quickly, but for a next question it would be great if you could add some context or maybe an example :D.
OK. Thank you.